Ribbon Cartridge Replacement; Error Codes - Amano PIX-200 Manual De Instrucciones

Ribbon Cartridge Replacement

NOTE: Before replacing the ribbon cartridge, disconnect the power plug from the power outlet.
1. Remove the cover.
2. Pull the two ribbon release tabs upward.
3. While holding the release tabs in an upward position,
pull the ribbon cartridge out of the cradle.
4. Insert a new ribbon underneath the printer
head as shown.
5. Turn the knob on the cartridge clockwise one turn to
take up any slack in the ribbon.
6. Connect the power to the outlet.
7. Reset the INK capacity gauge by pressing the (+) and (-)
buttons at the same time for more than 2 seconds.
8. Replace the cover.
9. Check the printing quality to confirm that you have
installed the ribbon properly.

Error Codes

In the event of an error, an error code will appear in the display. The error codes are listed below
along with their possible causes and solutions. The error code will be displayed for 2.5 seconds.
Error
Display
Home Sensor Error when starting imprint
Timing Sensor Error
Home Sensor Error when finishing imprint
Printing Length Setting Error
If the error does not dissapear, please contact your local dealer.
22
Cause Action
Unplug the time recorder/stamp and make
sure that the carriage is not stuck or jammed.
Also check to see that the ribbon cassette is
correctly inserted in place. Unplug the clock
and plug it back in.
Change the print length by adjusting Year
Digit, Type of Hour, kind of Languages and
Number Digit