Setting The Display And Password - Amano PIX-200 Manual De Instrucciones

Setting the Display and Password

In this setup, you can select the display.
1. Unlock and remove the cover. Press (+) and (E) button at the same
time for 2 seconds. The "set up program" display will appear.
2. Press the (+) button eleven times to position the " " at the fifth
from the upper right corner.
3. Press (E) button and you will see "P1 LCd diSPly" display where
you can set the display. Press (E) button and you can select either
"12-31-06" which displays the Month-Date-Year, or "No.12345678"
which displays the number, or "No.123456 RPT.9" which displays
the number and repeat times, or "LinE 3" which displays the line
number of the customized comment, or "L-6 rAdo" which displays
the level of radio wave strength for the atomic clock signal by pressing
(-) or (+) button.(The level number will increase when the radio wave
signal is stronger) Press (E) button to confirm your setting.
4. When you see the "P2 Hour diSPly", press (E) button to select either
"AM PM 12:00" which is AM/PM display or "23:59" which is 24 hour
display by pressing (-) or (+) button. Press (E) to confirm your setting.
5. When you see the "P3 PASS word", press (E) button to set the
password. The first digit will blink and you can select the first digit by
pressing (-) or (+) button. Once you select the first digit, press (E) to
confirm and select the remaining three digits following the same steps.
NOTE: When you would like to cancel the password, change the
first digit to "-" and the password will change to "----".
6. After confirming the password, you will see "P4 CloC SynC" where you can set the time zone
(US only), select the Official Standard Frequency (Europe) and whether to turn on the Atomic
Clock function or not.
When the unit requires the password
When you press (+) and (E) button at the same time for 2 seconds to enter the "set up
program" display.
When you press (+1 HOUR) or (+1 MIN.) to change the time.
In case you forget the password
You can enter the "set up program" display by entering "1441". Only use (-) button when you input the password.
17