Compliance - OHAUS Pioneer PXP Serie Manual De Instrucciones

EN-40
11.

COMPLIANCE

Compliance to the following standards is indicated by the corresponding mark on the product.
Mark Standard
This product complies with the EU Directives 2014/30/EU (EMC), 2014/35/EU (LVD) and
2014/31/EU (NAWI). The EU Declaration of Conformity is available online at www.ohaus.com/ce.
EN 61326-1, AS/NZS 61010-1
CAN/CSA-C22.2 No. 61010-1
UL Std. No. 61010-1
Important notice for verified weighing instruments in the EU
When the instrument is used in trade or a legally controlled application it must be set up, verified and sealed in
accordance with local weights and measures regulations. It is the responsibility of the purchaser to ensure that all
pertinent legal requirements are met.
Weighing Instruments verified at the place of manufacture bear the following supplementary metrology marking on
the descriptive plate.
Weighing Instruments to be verified in two stages have no supplementary metrology marking on the descriptive
plate. The second stage of conformity assessment must be carried out by the applicable weights and measures
authorities.
If national regulations limit the validity period of the verification, the user of the weighing instrument must strictly
observe the re-verification period and inform the weights and measures authorities.
As verification requirements vary by jurisdiction, the purchaser should contact their local weights and measures
office if they are not familiar with the requirements.
FCC Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Industry Canada Note
This Class A digital apparatus complies with Canadian ICES-003.
ISO 9001 Registration
In 1994, OHAUS Corporation, USA, was awarded a certificate of registration to ISO 9001 by Bureau Veritas
Quality International (BVQI), confirming that the OHAUS quality management system is compliant with the ISO
9001 standard's requirements. On June 21, 2012, OHAUS Corporation, USA, was re-registered to the ISO
9001:2008 standard.
This product complies with the EU Directive 2012/19/EU (WEEE). Please dispose of this product in
accordance with local regulations at the collecting point specified for electrical and electronic
equipment.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
PXP Series Balance