Recording Samples- Advanced Operation; About The Available Sampling Times; Specifying The Type Of Data To Create When Sampling; Starting Sampling Automatically (Auto Sampling) - Roland SP-404SX Manual Del Usuario

Recording Samples— Advanced Operation
MEMO
This section explains more advanced methods of
sampling. For basic sampling, refer to "Recording
Samples— Basic Operation" (p. 16).
About the Available Sampling
Times
The maximum sampling time (size) for a single sample is
approximately 180 minutes in stereo (2 GB).
You'll be able to store a larger number of samples if you
use a high-capacity SDHC card.
The following table shows the approximate total sampling
time of the samples that can be stored on one SD card.
Card Stereo
capacity (mono)
Approx. 90 min.
1 GB
(180 min.)
Approx. 180 min.
2 GB
(360 min.)
Approx. 360 min.
4 GB
(720 min.)
MEMO
Since the 1 GB SD card included with the SP-404SX
contains preload data, the available sampling time will
be less than the time above.
Remaining sampling time
1. When you press the [REMAIN] button, the display
will indicate the remaining time .
0 . 1 1 10 . 3
Min. Sec. Min. x10 Sec.
MEMO
The indication shows the time available for sampling
in stereo mode. The remaining time indication is an
estimate.
Card Stereo
capacity (mono)
Approx. 720 min.
8 GB
(24 hours)
Approx. 24 hours
16 GB
(48 hours)
Approx. 48 hours
32 GB
(96 hours)
17 3 24 H
Min. Hours
Specifying the Type of Data to
Create when Sampling
The data produced when sampling with the SP-404SX
can be saved in either the WAV (.wav) format or AIFF (.aif )
format. If you want to change the format of the data that is
created when you sample, carry out the procedure below.
1. Hold down the [RESAMPLE] button and turn on
the power .
2. Press the [PATTERN SELECT] button to switch
between WAV and AIF .
UA U A i F
Either " " (WAV) or "
when you press this button, showing you the current
selection.
3. Press the [RESAMPLE] button to confirm your
choice of file type .
MEMO
This setting will be remembered even after the power
is switched off.
Starting Sampling
Automatically (Auto Sampling)
The Auto Sampling function will cause sampling to begin
automatically when the input signal (sound) exceeds a
specified level. This is convenient when you want to begin
sampling from the introduction of a song. Before you enter
sampling standby mode, adjust the sampling trigger level
as described below.
1. Hold down the [FUNC] button and press the pad
[4] (AUTO TRIG LEVEL) .
The [REC] button will blink, and the display will indicate
" - 0- . "
2. Turn the [CTRL 3] (LEVEL) knob to set the level .
The sampling trigger level will be the level at which the
PEAK indicator lights. Turning the knob toward the right
will raise the level. The display will indicate the level you
specified (ten stages, 0–9).
MEMO
- 0-
When " " is indicated, conventional sampling will
occur (i.e., auto sampling will not be used). Choose the
-0 -
" " setting if you don't want to use auto sampling.
3. To check the sampling trigger level, press the
[REC] button once again .
When you start sampling with auto sampling specified,
the display will indicate "
sampling trigger level is received.
" (AIFF) appears in the display
rd Y
" until a signal exceeding the
25