Operator Position; Operation; Bead Breaking - SICE S 45 Basic Manual De Instrucciones

ENGLISH • Instructions manual

OPERATOR POSITION

Figure M5 shows the operator's positions during the various work phases:
A Bead breaking
B Tyre demounting and mounting
C Inflation area.
WARNING!
During all operations, keep hands and other parts of the body as far as possible from moving parts of the
machine.
Necklaces, bracelets and too large clothes, can be danger ous for the operator.
WARNING!
The optional PT accessory and/or other specific accessories are required to work on RUN FLAT, LOW PROFILE or
UHP wheels.
For use of the accessories and the correct operating procedure, refer to the manuals supplied with the
accessories themselves, approved by WDK.

10.1 BEAD BREAKING

WARNING!
Bead breaking must be done with the utmost care
and attention.
When the bead breaker pedal is operated the bead
breaker arm moves quickly and powerfully.
Anything within its range of action can be in danger
of being crushed.
WARNING!
Remember to remove all weights from both sides of the
rim before operating the machine.
1) Deflate the tyre completely and remove the valve core.
2) Close the table top gripper slides completely.
WARNING!
Bead breaking with the table top slide grippers open can
crush the operator's hands.
During bead breaking NEVER touch the walls of the tyre
with your hands.
3) Open the bead loosener by hand by pushing it towards the outside. Place
the wheel up against the rubber wheel support (13, Fig. L).

10. OPERATION

2
33
C
11
9
10
16
12
6
7
5
1
15
3
A
B
M5
8
4
14
13
L
S 45 Basic