LAMA HI1M Manual Del Usuario página 29

Personalised programming of the user
In order to have access to the menu of the user's programming,
press the two black buttons (A and B) simultaneously (Figure 1)
To go from one menu to another press the first black button (A) of the
control panel (Figure 2). The position of the cursor indicates the chosen
option in the menu (Figures 3 and 4).
Figure 3
In general, data is introduced into the programmer by pressing the green button (D), which increases a unit
(figure 5), and by pressing the red button (C), a unit of the chosen option is reduced (figure 6).
Programming Screens
Figure 5
• LIMPIEZA HORARIA (cleaning time): It establishes the time taken between two cle-
aning cycles, programmed by a clock.
• DURACIÓN LAVADOS (duration cleaning proceses): Period of time between the
beginning and the end of a cleaning process, it can be programmed between 0
and 255 seconds.
• T. ENTRE LAVADOS (time between cleaning procesess): Period of time between
the end of a cleaning process and the beginning of the next, it can be program-
med between 0 and 255 seconds.
• ESTAC. FILTRADO (filtering station): It Indicates the number of filters the pad has.
• TIEMPO P .D.(P .D time): It is the time of delay from the moment the pressure dif-
ference is detected to the beginning of the cleaning cycle. It can be programmed
between 0 and 255 seconds
• TIEMPO INICIO M. (Initial time of the master valve): It specifies the delay time of the master valve until the beginning
of the cleaning cycle. It can be programmed between 0 y 255 seconds.
• TIEMPO FINAL M.(final time M): Time for ending the setting off of the master valve, in order to avoid lower pres-
sures at the end of the cleaning cycle. It can be programmed between 0 a 255 seconds.
• UNIDAD DE MEDIDA (measuring unit): It specifies the type of unit the pressure is measured with, it may be BAR or PSI.
• NS: Series Number of the programmer
• PR.DIFERENCIAL (Differential PR): It is the difference between the inlet pressure (P+) and the outlet pressure (p-) to
start the cleaning cycles. It can be programmed between 0.1 and 0.9 BAR or 1.4 and 13 PSI
• 10/09/02 11:30 0290: It shows the date and time of the last setting to zero of the partial counter of cleanings
and the number of cleanings of the partial counter. In order to set the counter to zero, place the cursor on this option
and press the green button (D).
• 01/10/02 12:30 ESP: It shows the current time and date and the language of the programmer ESP (Spanish) , ING (English)
and FR (French).
FL8I Intelligent programmer - 220V / 115V
Figure 4
Figure 6
Figure 1
Figure 2
CONEXIÓN
Figure 7 Figure 8
EN
29