JF 2 Serie Manual Técnico De Operación página 20

C- Boocker
The boocker (8) deflects the product turning easier its
gathering.
a) Install the boocker (8), fastening it with the pins (9 and
10). Also install the lock pins (11) according to picture
below.
Note 1: The pin (9) adjusts the boocker advance (8). The
higher are the plants to be harvested, more advanced
the boocker should be and vice-versa.
Note 2: The pin (10) adjusts the boocker inclination (8).
The larger is the volume of the plants to be harvested,
more lifted up the boocker should be and vice-versa.
Note:
1- When removing the pins 9 and 10, always
make sure the boocker is well supported.
Because otherwise, it can abruptly move
down and cause injuries to the limbs of the
body near it.
2- This type of boocker is avaiable only in
machines with polyethylene shield.
Assembly of the washers in the Cross-
Link`s Outlet chute
Attention!
The washers that hold the outlet chute must
be attached with the rounded corner face
down (facing the outlet chute) and the
straight face upward (toward the nut), thus
avoiding friction of the washer with the outlet
chute, which can lead to the breaking of it.
20
8
11
9
10
Face rounded down!
8