Generator Maintenance; Changing Engine Oil And Filter; Changing Oil; Changing Oil Filter - Briggs & Stratton Standby Manual De Instalación, Arranque Y Propietario

GENERATOR
MAINTENANCE
The generator warranty does not cover items that have
been subjected to operator abuse or neglect.To receive full
value from the warranty, the operator must maintain the
engine as instructed in the engine owner's manual.
IMPORTANT: Before performing any maintenance on the
generator, be sure you follow all steps in "Servicing the
Generator" on page 19.
Generator maintenance consists of keeping the unit clean.
Operate the unit in an environment where it will not be
exposed to excessive dust, dirt, moisture or any corrosive
vapors. Cooling air louvers on the enclosure must not become
clogged with snow, leaves, or any other foreign material.
Check the cleanliness of the unit frequently and clean when
dust, dirt, oil, moisture or other foreign substances are
visible on its exterior/interior surface.
NOTE: DO NOT use direct spray from a garden hose to
clean generator.Water can enter the engine and generator
and cause problems.

Changing Engine Oil and Filter

Remove the two screws from each plastic access cover and
remove both access covers from the two sides of the
generator enclosure.

Changing Oil

1. Place oil drain tube into approved container.
2. Push in and rotate oil drain fitting 1/4 turn
counterclockwise. Slowly pull outward until oil starts
draining (Figure 11). DO NOT pull oil drain fitting off
engine.
Figure 11 — Oil Drain Fitting
3. When oil has drained, push oil drain fitting in and
rotate 1/4 turn clockwise until it locks in place.
More user manuals on
• Refer to engine manual for oil fill information.
Briggs & Stratton Power Products Home Standby Generator
Installation, Start-Up and Owner's Manual
ManualsBase.com
• Damage to equipment resulting from failure to follow this
4. Slide oil drain tube up into clamp on generator.

Changing Oil Filter

1. Place oil drain tray over tubing and slide it under oil
filter (Figure 12).
Figure 12 — Changing Oil Filter with Oil Drain Tray
2. Follow instructions given in engine owner's manual for
changing oil filter.
3. Remove oil drain tray from under oil filter and clean
up any spilled oil.
Avoid prolonged or repeated skin contact with used
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
To fill your engine with oil:
• Follow synthetic oil grade recommendation given in
"Engine Oil" on page 17 and oil fill instructions given in
engine owner's manual.
20
instruction will void warranty.