Know Your Control Panel - Briggs & Stratton Standby Manual De Instalación, Arranque Y Propietario

KNOW YOUR CONTROL PANEL

Compare this Control Panel illustration with your generator to familiarize yourself with the location of these important
controls:
LED Light
Circuit Breaker
15 Amp Fuse — Protects the Home Standby Generator
DC control circuits. If the fuse has melted open or was
removed, the engine cannot crank or start. Replace the fuse
using only an identical BUSS AGC 15A fuse.
START/RUN/STOP Switch — This three-position
switch is used as follows:
• "START" position starts the generator.
More user manuals on
Briggs & Stratton Power Products Home Standby Generator
Installation, Start-Up and Owner's Manual
ManualsBase.com
• "RUN" position is the normal operating mode. Allows
you to start generator from a remote switch.
• "STOP" position turns off generator.
Circuit Breaker — Protects the system from over-
current conditions and must be in the "On" position to
supply power to the Transfer Switch.
LED Light — Indicates when generator is running or off.
7
15 Amp Fuse
START/RUN/STOP
Switch