SCHUBERTH E1 Manual De Usuario página 40

C. THE HELMET
Note:
Only use the slide to operate the sun visor.
Caution:
Never ride in the dark or in conditions of poor visibility with the sun
visor down. Always raise the sun visor before entering a tunnel.
Caution:
Riding without the face shield or with an open face shield can result
in injury to the eyes and face from stones, dust, insects and other
flying objects. The sun visor, when lowered, will offer a certain amount
of protection from light impact from stones or insects but does not
provide protection against all hazards.
REPLACING THE SUN VISOR
The sun visor can be replaced without tools.
Tip:
To avoid fingerprints and scratches, use a soft, clean cloth
(we recommend a microfibre cloth) to hold the sun visor when
removing or installing it.
Tip:
Changing the sun visor is easier when the chin section is open and
locked in place. It is also helpful if you place the helmet on a flat
surface or on your lap while seated.
Note:
Try to prevent the sun visor coming into contact with the helmet's
inner shell when removing or fitting it.
76
Removing the sun visor
1. Open and lock the chin section in
place.
2. Pivot the sun visor down.
3. Bend the middle snap connection with
locating pegs gently outwards until
the sun visor is released from the visor
holder.
4. Repeat this step for the other side.
Tip:
The sun visor holders should remain in the lower position while you
install the visor.
Fitting the sun visor
1. Put the sun visor between the snap
connections and fit it on to the locating
pegs on one side and then on the
other.
2. Position the sun visor between helmet
inner and outer shell and lower it with
the operating slide.
3. For safety, check that the sun visor
mechanism is functioning correctly.
EN
77