Maintenance And Care; Chin Section; Face Shield And Sun Visor - SCHUBERTH E1 Manual De Usuario

G. MAINTENANCE AND CARE
1. OUTER SHELL
To clean the helmet shell and the shield you can use water, soap or one of
the commonly available motorcycle shampoos, cleaners, polishes, plastic
cleaners or cleaning fluids. Using water and soap is usually sufficient. Make
sure when using the other cleaning materials that these do not come into
contact with the face shield, since they can cause damage to the visor and
its coating.
Note:
Never use motor fuel, thinners or solvents to clean the helmet. These
substances can cause serious damage to the helmet with no external
signs. The full safety function of the helmet can then no longer be
guaranteed.

2. CHIN SECTION

Please check the functionality of the chin part at regular intervals.
Caution:
Alterations to the strap buckle are not permitted. In particular,
you should not oil or grease the metal components of the chin
section lock. Repairs may only be carried out by the SCHUBERTH
Repair Service.

3. FACE SHIELD AND SUN VISOR

OUTER SURFACE OF THE FACE SHIELD
Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt from the
outside of the face shield. To dry the face shield, use a lint-free cloth and
apply gentle pressure.
96
ANTI-FOG LENS
The inside surface of the anti-fog lens must only be cleaned with a soft cloth,
which may be slightly dampened if required (we recommend a mocrofibre
cloth). Do not use any cleaning agents.
SUN VISOR
The sun visor should only be cleaned with a soft and, if necessary, slightly
damp cloth (we recommend a microfibre cloth). Do not use any cleaning
agents.
Note:
Only use tepid water (< 20 °C) for cleaning. Never on any account
clean the face shield or sun visor with petrol, solvent, a window or glass
cleaner or other cleaning agents containing alcohol.
Note:
The face shield should not be soaked in water even if it is very dirty on
the outside, as this will severely reduce the surface hardness and thus
the durability of the anti-fog/anti-scratch coating.
Note:
The face shield should not be completely closed when not in use
(particularly during periods of storage), as the moisture contained
on the inside cannot escape if closed and will largely be absorbed by
the anti-fog/anti-scratch coating. This can lead to a reduction in the
lifespan of the coating. Ideally, position the face shield in the third
locking setting above the urban position.
Note:
Never attach labels, adhesive tape or stickers to the face shield or
sun visor.
EN
97