Preparation For Use; Required Tools; Installation - Ottobock 491S75-ST150 Instrucciones De Uso

Preparation for use

Item Article designation
2 Spacer strip, PVC, 5 mm
Parts from the basic kit supplied by Dahl (see fig. 2, right)
Order number
Item Article designation
3 Locking plate (500561*)
4 Intermediate piece, 8 mm (500673*)
5 Mounting screws M8x45, Torx (502800*)
* Listed Dahl order numbers. Order via: Dahl Engineering ApS | Løvevej 3 | DK-7700 Thisted | Denmark | Tel: +45
96 18 00 77 | sales@dahlengineering.dk | http://www.wtors.com
6 Preparation for use

6.1 Required tools

The following tools are required for adjustments and maintenance work:
INFORMATION
The following list only includes tools which are required for the direct assembly of the parts specified in the scope
of supply of Dahl and Ottobock. Please refer to the service manual for information on tools for preparatory work
(e.g. for the removal of the battery).
• Allen key, size 6
• Ring and open-ended wrenches, size 8, 24
• Torque wrench (measurement ranges 5-50 Nm)
• Torx screwdriver, size T45
• Metal saw
• Scissors or cutter knife
• Liquid thread lock, "medium strength" (e.g. Loctite 241)

6.2 Installation

Safety instructions for the installation of the Dahl parts on the Ottobock power wheelchair
WARNING
Non-observance of the Dahl user guide
Severe injury in case of accidents due to installation errors
► The installation and safety instructions supplied by Dahl, which are included with the installation and operat­
ing instructions for the Dahl docking system, must be observed during all installation work.
► The following installation notes are only valid in conjunction with the installation and operating instructions
supplied by Dahl.
CAUTION
Incorrect use of mounting screws
Severe injuries due to breakage of the Torx mounting screws
► Only use the Torx mounting screws supplied by Dahl Engineering. Other standard screws are not strong
enough to hold the attachment plate in case of a collision.
► Please note that the Torx mounting screws have to be shortened during installation. Do not damage the thread
when shortening the screws.
► Please note that the Torx mounting screws have to be secured with "medium strength" liquid thread lock
(e.g. Loctite 241) during installation.
16
501750*
Quantity
2
Quantity
1
1
5
491S75=ST150, 491S75=ST155