Required Tools; Command Module; Variable Throttle Lever - Stroke - Waeco MagicSpeed MS700 Instrucciones De Montaje Y De Uso

MS-700.qxd 24/06/03
The tools required for the correct assembly of the cruise control are listed below: Alt-
hough this equipment can be mounted without some of the listed tools, we recommend
having these tools handy. It is highly recommended that you solder the connections to
ensure a stable connection.
- drill (see B 1)
- voltmeter (see
- soldering iron and material (see B 3)
- wire-cutting pliers (see
- insulation stripping tongs (see
- crimping pliers (see
- pliers (see
- drill set (see
- prick punch (see
- hammer (see
Module, (see
Throttle lever MS-700 can be adjusted with different strokes. The two lengths are either
38 mm or 45 mm. The stroke required, however, depends on the stroke of the vehicle
throttle valve or accelerator pedal. The length of the throttle lever stroke can be adjusted
by turning the flangecoupling on the servo (see changing the throttle lever stroke).
To determine the necessary length of the throttle lever stroke, measure the stroke of the
vehicle throttle valve or accelerator pedal between basicposition and full engine
revolutions. Ensure that the correct flange coupling is mounted to prevent damage to the
original throttle valve cable, accelerator pedal or cruise control throttle lever.
15:19 Page 45

Required tools

B 2)
B 4)
B 5)
B 6)
B 7)
B 8)
B 9)
B 10)

Command module

C

Variable throttle lever - stroke

- car jack (see B 11)
- set of screwdrivers (see
- set of socket wrenches (see
- axle assembly bay (see
- insulating tape (see
- ruler (see B 16)
- screw wrench (see
- set of ring spanner wrenches (see
- sealing compound (see B 19)
45
B 12)
B 13)
B 14)
B 15)
B 17)
B 18)