Waeco MagicSpeed MS700 Instrucciones De Montaje Y De Uso página 58

MS-700.qxd 24/06/03 15:19 Page 58
Adjustment/training mode
Stop your vehicle to leave the SETUP program and press the SET button 4 times while
the brake is activated.
After each modification of the PPM setting, all previous INIT settings are overwritten with
the factory default settings; however, the GAIN setting remains unmodified.
If cruise control now takes over the speed too slowly or too jerkily, the INIT setting must
be performed. If cruise control works too slowly or jerkily in normal operation, the GAIN
setting must be performed manually.
If cruise control works too slowly or too jerkily in normal operation,
the GAIN setting must be performed manually.
4. INIT mode
You can adjust the sensitivity of the speed takeover inINIT mode.
If cruise control takes over the speed too slowly, the
INIT value must be increased. If the speed is taken over too jerkily, the INIT value must be
decreased.
First start the SETUP-program to reach the INIT setting mode.
Now press the RES button three times while the brake is activated. You will hear a low
acoustic signal as a confirmation of each keystroke. Release the brake. You will hear
three high acoustic signals asa confirmation after releasing the brake. If you do not hear
three high acoustic signals, the above-mentioned steps must be performed again.
Drive cruise control at any speed you like above the minimum speed (40 km/h). Now
press the SET button until you notice cruise control taking over the speed at which you
are driving. Switch off cruise control by activating the brake. Press the SET button again;
cruise control should now take over the speed gently. If this is not the case, you can
increase the INIT value using the SET button and decrease the value using the RES
button. You will hear an acoustic signal for each keystroke.
58