Maintenance - SATA SATAjet 1000 K RP Instrucciones De Servicio

Operating instructions SATAjet 1000 K RP/HVLP, SATAjet 1000 H RP
EN
• After cleaning, the spray gun, the material passages, the air
cap including thread and suction cup have to be blown dry
with clean compressed air!*
* otherwise risk of corrosion
• Check spray pattern after cleaning the nozzle set!
• Further tips concerning cleaning can be found at www.sata.com/TV.
9.

Maintenance

• Prior to maintenance, disconnect spray gun from the compressed air
circuit!
• Disassemble and assemble components very carefully! Exclusively
use included special tools!
9.1. Replacing the nozzle set
and [7-6]
Every SATA nozzle set consists of "paint needle" [7-1], "air cap" [7-2]
and "fluid tip" [7-3] and has been hand-adjusted to provide a perfect
spray pattern. Therefore, always exchange the complete nozzle set. After
installation, please adjust material flow according to chapter 7.2.
9.2. Replacing the air distribution ring
2], [7-3], [8-1], [8-2] [8-3], [7-4], [7-5] und [7-6]
• Remove air distribution ring with SATA extraction tool only.
• Do not apply force to avoid damage of sealing surfaces.
112
Warning! Attention!
Notice!
Warning! Attention!
Attention!
[7-1], [7-2], [7-3], [7-4], [7-5]
Steps: [7-1], [7-