SATA minijet 3000 B HVLP Instrucciones De Servicio página 408

Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP
US
182. Connect compressed air hose [2-14].
Material and air connection of SATAminijet 3000 B T HVLP
1. Connect the hose pair to the pressure tank with double pressure
reducer
2. Adjust required atomisation air pressure with the trigger fully pulled.
After this, adjust required material pressure with trigger fully pulled.
7.1. Adjustment of the Spray Gun Inlet Pressure
• Pull the trigger fully and adjust the spray gun inlet pressure (see
chapter 2) following instructions of one of the followig sections ([3-1],
[3-2], [3-3] to [3-4]), then release the trigger.
• With [3-2], [3-3] and [3-4], the air micrometer [1-13] has to be fully
opened and in vertical position.
• If the required spray gun inlet pressure is not reached, the pressure
at the compressed air circuit has to be increased; too high pressure
results in too high trigger forces.
[3-1] SATA adam 2 mini (accessory / accurate method).
[3-2] Separate analogue gauge with regulation device (accessory).
[3-3] Separate analogue gauge without regulation device (acces-
sory).
[3-4] Pressure regulation at the compressed air circuit (least ac-
curate method):
rule of thumb: pressure at the pressure reducer must be set 0.6
bar higher than the recommended spray gun inlet pressure per
every 10 m of air hose (inner width 9 mm).
7.2. Adjustment of the Material Flow
und [4-4] - material flow control fully opened
With the material flow control fully opened, the wear of the fluid tip and
paint needle is reduced to a minimum. Please select the correct nozzle
size depending on the material to be applied and the required applica-
tion speed.
408
Information!
Information!
[4-1], [4-2], [4-3]