Removal From Storage - Lavorwash INDEPENDENT 2000 Manual De Instrucciones

II. STORAGE
EN
If the engine is not kept in use for a long time, be sure to
store it properly. Make sure the storage area is dry and free
of dust.
1. Replace engine oil (Fig. 32).
2. Disconnect the spark plug. Fill a spoon of fresh engine oil
from the sprak plug mount hole into the cylinder. Rotate the
engine to distribute engine oil evenly, followed by fitting
the sprak plug to original position.
3. Pull the starting rope slowly until feel a slight anti-action,
and then keep pulling so as to align the arrow of the
starting sleeve with the hole of the starter. At this
time, both the inlet and outlet valves are closed so to
help prevent the engine inside from rusting (Fig. 33).
4. Cover the engine so keep dust away.
III. REMOVAL FROM STORAGE
Before reusing, service the engine in accordance with
the instructions of the table.
Storage time
Within one month
One - two months
Two months - one year
Above one year
1 Screw off the drain plug and drain out fuel in the carburetor.
2
Turn off the engine switch first, disconnect the deposit cup and empty it.
Note: For the sake of environmental protection, we recommend to fill the discarded fuel into a
closed container and bring to local recycling station.
Never pour freely.
WARNING
Fuel is extremely flammable and explosive under certain conditions. Keep cigarette,
open flames and sparks away from operating site.
36
Drain
plug
Service item
Drain out original fuel of the fuel tank and refuel.
Drain out original fuel of the fuel tank and refuel;
Drain out fuel in the carburetor
2
Empty the deposit cup
Drain out original fuel of the fuel tank and refuel;
Empty the fuel cup in the carburetor
Empty the deposit cup 2
Move the engine from the storage place, fill it with fuel,
then start up it.
Deposit
cup
fig. 32
Align the arrow
of the starting
sleeve with the
hole in the starter
fig. 33
1
;
.
1
;
;