Reassembling The Jay Balance; Cushion After Cleaning - Jay 126042 Manual Del Usuario

ENGLISH
To clean fluid pad:
Remove the cover from the foam base. Remove fluid pad from
the inner cover and wipe with warm water and soap. Rinse with
a clean, damp cloth. Then wipe dry with a clean cloth.
CAUTION!
• Never submerge the fluid pad in any liquid
• Avoid harsh cleaning or rough handling as this may lead to
a degradation of the fluid insert.
If at any time, the outer cover, inner cover, foam base, fluid
insert or any other component appears to be wearing or you
notice a degradation in the texture, contact your supplier/
Sunrise for evaluation and further instructions.
NOTE: To clean the ROHO® DRY FLOATATION® Pad (if
applicable), reference the ROHO® DRY FLOATATION® Pad
Owner's Manual Supplement for proper cleaning instructions.
LAUNDRY CARE SYMBOLS
JAY Balance Cushion 126042
Machine wash in warm water
(60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
M AI NT E NA NCE - RE F I T T IN G

REASSEMBLING THE JAY BALANCE

CUSHION AFTER CLEANING

Follow cleaning and maintenance instructions as described in
"Easy maintenance and cleaning" then reassemble as follows.
WARNING!
• Place the JAY Fluid or ROHO® DRY FLOATATION®
Pad on the inner cover making sure that all Velcro®
strip locations are aligned. A misalignment or creation
of an edge could cause an unwanted pressure point
which could lead to injury.
Insert the foam base / inner cover assembly into the outer
cover. Ensure that the zipper is at the rear of the foam base
where the pelvic loading area is located.
Roho® Dry Floatation® Pad
7
Fluid Insert
Inner Cover
US = Rev. B, EU = Rev.1.0