SFS isoweld 3000 Instrucciones De Operación página 19

10a
10b
10c
6. Operate main switch to turn unit on.
7
7 . The display shows the input screen.
8. Perform start-up calibration and test weld
5
procedures. (see pages 20 & 21)
These procedures must be performed prior
6
to putting the backpack on.
The country-specific regulations must be
observed.
First, inspect the shoulder straps to
ensure they are not damaged and that they
are firmly connected to the tool body with no
damage or wear at the connection points.
9. After inspection, place your arms through the
shoulder straps to support the backpack on
your back.
Using a tool with damaged straps or
connection points may result in a strap or
connection breaking while in use and the
machine may fall causing personal injury.
If there is any damage noted to the straps or
connections, follow the instructions noted in
the maintenance, service and warranty
section of this manual.
10. Adjust the straps
10a. Adjust the shoulder straps to a good
10b. Attach the chest strap and adjust to
10c. Attach the waist strap and adjust its
11. Use the cord management straps to organize
the power cord and inductor cord for safe,
efficient working.
WARNING!
working fit by adjusting the strap
length at the clip
length
length so that the machine is
supported by your hips.
19