Operation; Turning On Indicator; Turning Off Indicator; Zero Operation - OHAUS CD-11 Manual De Instrucciones

EN-26

4. OPERATION

Before using the Indicator, make sure it has been properly set up and calibrated. Refer to Sections 2 and 3 and
the Overview of Controls and Indicator Functions to review settings.

4.1 Turning On Indicator

Press the ON ZERO/ Off button until the LCD display
appears. The display momentarily displays segment
check, the software version of the Indicator and then goes
into a weighing mode. The weighing mode and decimal
point position may be different depending on the setup of
the Indicator.

4.2 Turning Off Indicator

To turn the Indicator off, press and hold the ON ZERO/ Off
button until OFF is displayed.

4.3 Zero Operation

Press the ON ZERO/ Off button to zero the Indicator. The display acknowledges
by indicating the selected measuring unit followed by a zeroed display.
NOTE: Stable cursor must be lit to accept zero operation.
Place item to be weighed on the scale platform. The display indicates a sample
of 5kg, gross weight.

4.4 Tare Operation

When weighing material or objects that must be held in a container, taring
stores the container weight in the Indicator's memory. To store the container
weight, proceed as follows:
Place the container on the scale. Sample shown is 2kg.
Press the TARE button. Scale is tared and shows Net weight.
NOTE: Stable cursor must be lit to accept tare operation.
If the tare weight is removed from the scale, the Net weight is displayed as a
negative value
Stable Display PCS Gross Net
Hold Brutto
ON/ZERO
2II
G/N/T
PRINT
0HQX
8QLWV
> 0 < > 0 <
> 0 < > 0 < > 0 <
Stable
Stable
Stable
Stable
Stable
CD-11 Indicator
Tare
TARE
Gross
Brutto
Gross
Brutto
Gross
Brutto
Net
Net