The Drive Mode; Start / Stop Drive; Change Direction Of Rotation; Preset Set Value - KEB COMBIVERT F4-S Serie Manual De Instrucciones

Drive mode

4.7 The Drive Mode

4.7.1 Start / Stop Drive

GB
4.7.2 Change Direction
of Rotation

4.7.3 Preset Set Value

4.7.4 Leave Drive Mode

42
The drive mode is a operating mode of KEB COMBIVERT to start the
drive manually by the operator. After switching the control release the set
value and rotation presetting is done exclusively by the keyboard. In order
to activate the drive mode the corresponding password in CP.0 must be
entered. The display switches over as follows.
Direction of rotation
F=forward / r=reverse
Modulation blocked
Drive not controlled
START
Drive accelerates onto
the adjusted set value
STOP
START
To exit the drive mode the inverter must be in status "stop" (Display noP
or LS). Press the FUNC and ENTER keys simultaneously for about 3
seconds in order to leave the drive mode. The CP-parameters appear in
the display.
+
FUNC.
SPEED
noP = no control release /
LS = neutral position
Drive decreases to 0 Hz and
switches the modulation off
Drive changes direction
ENTER
of rotation
F/R
Display changes when key is
FUNC.
pressed to set value display/
SPEED
presetting
Set value can be changed
with UP/DOWN at pressed
FUNC/SPEED key
ENTER
for 3 seconds
F/R
Status
STOP
Drive operates with
adjusted set value