Before The First Ride - RIESE & MUELLER Charger Manual De Instrucciones

BEFORE THE FIRST RIDE

ATTENTION!
Your specialist dealer must provide
the E-Bike in a condition ready to
ride in order to ensure safe opera-
tion. The dealer must perform a final
inspection and a test ride. Handover
of the E-Bike must be documented
in the E-Bike Logbook (see pages 51
and 53).
Check the tightness of the quick-
release skewers and all main fixing
screws and nuts.
Check the tires' air pressure. The
specified tire pressure is stated on
the side wall of the tires. Comply
with the specifications for minimum
and maximum pressure! Check the
tires and wheels for damage, cracks
and deformation.
Check the battery is inserted securely.
Check the charge status of the battery.
Familiarise yourself with the func-
tions of all controls.
EN-10
DANGER!
If the assistance mode is turned
on your E-Bike will start mov-
ing as soon as you put your foot
on the pedal. When getting onto
your bike you should therefore
make sure you apply the brakes
first and don't put your foot on a
pedal. The unfamiliar push can
otherwise cause a fall, hazard or
accident.
CARRIERS, CHILD SEATS
Please note that it is not permitted to modify
carriers in any way. Only use tested and
approved child seats.
TRAILER/TRAILERBIKES
Full-suspension Riese & Müller E-Bikes are
only approved for use with two-wheel trai-
lers. The maximum trailing load (trailer incl.
cargo load) is 50 kg. If attached to the carrier,
the tongue load needs to be added to the
carrier's load.
Riese & Müller E-Bikes without rear wheel
suspension are also approved for use with
single wheel trailers. The maximum trailing
load is 20 kg for all models.