Adjustable Stem - RIESE & MUELLER Charger Manual De Instrucciones

ADJUSTABLE STEM

Some Riese & Müller E-Bikes are fitted
with an adjustable stem. Thanks to snap-in
locking and quick-release skewer it can be
adjusted without tools.
Adjusting the angle
• Open both quick-release skewers A at the
stem joint.
• Push the sliding knob B on the side and
adjust the stem to one of the three angular
positions. Let go of the knob for it to lock
back into place (if necessary slightly move
the stem forwards and backwards).
• Attention: Only the three stem positions
with engaged pin can be used.
• Always close the quick-release skewer A on
the side of the pin B first. The lever force
should increase significantly in the second
half of the motion.
• Once engaged, the red lines E on the side
of the stem joint need to line up.
A
E
ATTENTION!
Before every ride, ensure that the pins are correctly engaged and the quick-release
skewers closed completely. Should the handlebars or the stem move while riding,
do not continue. Immediately take your bike to your specialist dealer to get the stem
checked. This could otherwise lead to crashes and serious injuries.
EN-16
Height-adjustment:
• Open the quick-release skewer C.
• Push the pin D and adjust the stem to one
of the five height positions until the pin D
locks back into place.
• Straighten the handlebars to align with the
direction of travel and close the quick-re-
lease skewer C. The lever force should
increase significantly in the second half of
the motion. If the clamp force is not
B
ATTENTION!
The stem must not be pulled out
further than the "MIN. INSERTION"
mark F. Only the five height positions
with locked-in pin can be used.
sufficient, the
specialist dealer
must adjust
the quick-release
C
skewer.
D
F