Replacing The Red Silicone Rubbers Of The Tray Dies; Replacing The Neoprene Gaskets Of The Sealing Head - Orved N Serie Manual De Uso

ROUTINE MAINTENANCE

10.6 REPLACING THE RED SILICONE RUBBERS OF THE TRAY DIES

1) Check to make sure the spare part corresponds to the silicone rubber to be replaced.
2) Remove the red silicone rubber from the tray die F
and clean the seat to remove residual dirt, if any, using compres-
sed air.
3) Insert the new basket by pressing it all the way into the cavity, gluing it with universal glue, if necessary.
F

10.7 REPLACING THE NEOPRENE GASkETS OF THE SEALING HEAD

1) Open the sealing head.
2) Remove the two gaskets G H
and and clean the seats to remove residual dirt, if any.
3) Insert the new gasket by pressing it all the way into the hollow seat.
H
G
47
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N