Before Getting Started - Franklin Electric SubDrive15 Manual De Uso

Before Getting Started

s
WARNING
!
Serious or fatal electrical shock may result from failure to connect the ground terminal to the motor,
SubDrive/MonoDrive controller, metal plumbing, or other metal near the motor or cable, using wire
no smaller than motor cable wires. To minimize risk of electrical shock, disconnect power before
working on or around the SubDrive/MonoDrive system. CAPACITORS INSIDE THE SUBDRIVE/
MONODRIVE CONTROLLER CAN STILL HOLD LETHAL VOLTAGE EVEN AFTER POWER HAS
BEEN DISCONNECTED.
ALLOW 5 MINUTES FOR DANGEROUS INTERNAL VOLTAGE TO DISCHARGE BEFORE REMOVING
SUBDRIVE/MONODRIVE COVER.
Do not use motor in swimming areas.
s
ATTENTION
!
This equipment should be installed by technically qualified personnel. Failure to install it in compliance
with national and local electrical codes and within Franklin Electric recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure. Installation information
is available through pump manufacturers and distributors, or directly from Franklin Electric at our
toll-free number 1-800-348-2420.
s
CAUTION
!
Use SubDrive/MonoDrive only with Franklin Electric 4-inch submersible motors as specified in this
manual (see Table 2, pg. 19). Use of this unit with any other Franklin Electric motor or with motors from
other manufacturers may result in damage to both motor and electronics. In applications where water
delivery is critical, a replacement pressure sensor and/or back-up system should be readily available if
the drive fails to operate as intended.