Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
axial joint in the load line. The heel characteristics can be individually adapted with a function
module.
1.2 Combination possibilities
This prosthetic component is compatible with Ottobock's system of modular connectors. Func
tionality with components of other manufacturers that have compatible modular connectors has
not been tested.
2 Intended use
2.1 Indications for use
The product is intended exclusively for lower limb exoprosthetic fittings.
2.2 Area of application
Our components perform optimally when paired with appropriate components based upon weight
and mobility grades identifiable by our MOBIS classification information and which have appro
priate modular connectors.
The product is recommended for mobility grade 1 (indoor walker) and mobility
grade 2 (restricted outdoor walker).
m°
kg
Size [cm]
Stiffness 1
Stiffness 2
Stiffness 3
2.3 Environmental conditions
Storage and transport
Temperature range –20 °C to +60 °C (–4 °F to +140 °F), relative humidity 20 % to 90 %, no mechanical
vibrations or impacts
Allowable environmental conditions
Temperature range: –10 °C to +45 °C
Moisture: relative humidity: 20% to 90%, non-condensing
Chemicals/liquids: fresh water as dripping water, occasional contact with salty air (e.g. near the ocean)
Solids: dust
Prohibited environmental conditions
Chemicals/moisture: salt water, perspiration, urine, acids, soapsuds, chlorine water
Solids: dust in high concentrations (e.g. construction site), sand, highly hygroscopic particles (e.g. talcum)
Other environmental conditions
UV light
Hydrolysis
2.4 Service life
This product has been tested by the manufacturer with 2 million load cycles according to ISO
22675. Depending on the patient's activity level, this corresponds to a service life of 2 to 3 years.
10
Maximum body weight
22 to 23
24 to 25
52 kg
58 kg
68 kg
76 kg
80 kg
100 kg
Not resistant
Not resistant
26 to 27
28 to 30
72 kg
77 kg
95 kg
100 kg
125 kg
125 kg
Publicidad
Tabla de contenido
