Publicidad
Idiomas disponibles
Idiomas disponibles
4) Set the correction strength. In order to do so, push the rods firmly into
the joint up to the marking line and tighten the 2 Allen screws to a torque
of 6 Nm (see fig. 6).
Optional: Optimizing straps
► Remove the hook-and-loop closure of the strap (2) and shorten the strap.
Conducting the dynamic trial fitting
► Observe the position of the ankle joint and reduce the setting of the low
er leg component in case of a non-physiological heel strike (excessive
supination of the foot) (see fig. 7).
5.3 Application
CAUTION
Using the brace without padding
Risk of local pressure points, superficial injuries or skin irritation due to
skin contact with rigid or sharp brace components
► Only use the brace with undamaged padding.
CAUTION
Brace is put on too tightly
Risk of local pressure points and restriction of adjacent blood vessels or
nerves
► Check that the brace is correctly positioned and fitted.
NOTICE
Use of a worn or damaged product
Limited effectiveness
► Before each use, check the product for functional reliability and for
possible wear or damage.
► Do not continue using a product that is no longer functional, or that is
worn or damaged.
1) Unfasten the hook-and-loop closure of the strap.
2) Insert the brace into the shoe.
3) Put the brace on together with the shoe.
4) Fasten the hook-and-loop closure of the strap.
5.4 Removal
1) Unfasten the hook-and-loop closure of the strap.
2) Remove the shoe together with the brace.
15
Publicidad
