SATA SATAjet 3000 K RP Instrucciones De Servicio página 128

Operating Instructions SATAjet 3000 K (RP/HVLP)
EN
■ Purge paint channel with suitable cleaning solution.
■ Screw connection nipple [2-8] to air connection [1-7].
■ Align air cap.
Horizontal spray [2-7]
Vertical spray [2-6]
8.2. Normal Operation
Connect spray gun
■ Connect material coupling [2-11] and material hose [2-10].
■ Connect compressed air hose [2-9].
Adjust gun inner pressure
Note!
The air micrometer [1-4] must be fully opened (vertical position) in the
settings [3-2], [3-3] and [3-4].
Note!
The most precise way to adjust the gun inner pressure is with SATA
adam 2 [3-1].
Note!
If the gun input pressure does not reach the necessary level, increase
the pressure in the compressed air circuit.
Too much input pressure results in high trigger forces.
■ Pull trigger guard [1-10] right back.
■ Adjust the gun input pressure to one of the following settings [3-1],
[3-2], [3-3] to [3-4]. Note the maximum gun inlet pressure (see chap-
ter 7).
■ Bring the trigger guard to the starting position.
Adjust the material flow
Note!
When painting, only use as much material as is required for the specific
procedure.
When painting, maintain the necessary spray distance. After painting,
store or dispose of the material correctly.
128