Pneumatic Tires; G.POsitioning Belts; Power Drive; Push Handles - Quickie SR45 Manual De Instrucciones

E N G L I S H
F. PNEUMATIC TIRES
WARNING
Proper inflation extends the life of your tires and makes
your chair easier to use.
1. Do not use this chair if any of the tires is under- or over-
inflated. Check weekly for proper inflation level, as listed on
the tire sidewall.
2. Low pressure in a rear tire may cause the wheel lock on that
side to slip and allow the wheel to turn when you do not
expect it.
3. Low pressure in any of the tires may cause the chair to veer
to one side and result in a loss of control.
4. Over-inflated tires may burst.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
G. POSITIONING BELTS (OPTIONAL)
WARNING
Use positioning belts ONLY to help support the rider's
posture. Improper use of these belts may cause severe
injury to or death of the rider.
1. Make sure the rider can not slide down in the wheelchair seat.
If this occurs, the rider may suffer chest compression or suffo-
cate due to pressure from the belts.
2. The belts must be snug, but must not be so tight that they
interfere with breathing. You should be able to slide your
open hand, flat, between the belt and the rider.
3. A pelvic wedge or a similar device can help keep the rider
from sliding down in the seat. Consult with the rider's doc-
tor, nurse or therapist to find out if the rider needs such a
device.
4. Use positioning belts only with a rider who can cooperate.
Make sure the rider can easily remove the belts in an emer-
gency.
5. NEVER Use Positioning Belts:
a. As a patient restraint. A restraint requires a doctor's
order.
b. On a rider who is comatose or agitated.
c. As a motor vehicle restraint. In an accident or sudden
stop the rider may be thrown from the chair. Wheelchair
seat belts will not prevent this, and further injury may result
from the belts or straps.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
H. POWER DRIVE
WARNING
Do not install a power drive or power assist on any
Quickie wheelchair. If you do:
1. It will affect the center of balance of your chair and may cause
a fall or tip-over.
2. It will alter the frame and void the warranty.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
VIII. W RNINGS: COMPONENTS & OPTIONS
I. PUSH HANDLES
When you have an attendant, make sure this chair has

push handles.

1. Push handles provide secure points for an attendant to hold
the rear of this chair, to prevent a fall or tip-over. Make sure
to use push handles when you have an attendant.
2. Check to make sure push handle grips will not rotate or slip
off.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
J. QUICK-RELEASE AXLES
1. Do not use this chair UNLESS you are sure that both quick-
release rear axles are locked. An unlocked axle may come off
during use and cause a fall.
2. An axle is not locked until the quick-release button pops out
fully. An unlocked axle may come off during use, resulting in a
fall, tip-over or loss of control and cause severe injury to the
rider or others.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
K. REAR AXLES
A change in set-up of the rear wheels will affect the
center of balance of your chair.
1. The farther you move the rear axles FORWARD, the more
likely it is that your chair will tip over backward.
2. Consult your doctor, nurse or therapist to find the best rear
axle set-up for your chair. Do not change the set-up UNLESS
you are sure you are not at risk to tip over.
3. Adjust the rear wheel locks after you make any change to the

rear axles.

a. If you fail to do so, the locks may not work.
b. Make sure lock arms embed in tires at least 1/8 inch
when locked.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
L. REAR WHEEL LOCKS
Rear wheel locks are NOT designed to slow or stop a
moving wheelchair. Use them only to keep the rear
wheels from rolling when your chair is at a complete stop.
1. NEVER use rear wheel locks to try to slow or stop your
chair when it is moving. Doing so may cause you to veer out
of control.
2. To keep the rear wheels from rolling, always set both rear
wheel locks when you transfer to or from your chair.
3. Low pressure in a rear tire may cause the wheel lock on that
side to slip and may allow the wheel to turn when you do
not expect it.
4. Make sure lock arms embed in tires at least 1/8 inch when
locked. If you fail to do so, the locks may not work.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
11
WARNING
WARNING
WARNING
WARNING
118611 Rev. B