miniland baby digimonitor 3.5 plus Manual De Instrucciones página 27

ENGLISH
7. TROUBLESHOOTING
Problem
No reception on the
monitor
Only black and white
images are displayed
You cannot hear the
parents' voice in the
baby unit
The camera does not
transmit
You cannot hear the
baby on the parent unit
Interference or poor
reception
You cannot charge the
battery in the parent unit
If the Baby Unit has lost
its link with the Parent
Unit
Possible Cause
Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is not
plugged
Monitor out or range
Connection lost between the
monitor and a camera already
linked
A wrong camera has been selected
Check whether the camera is in
night vision/infrared mode
The volume setting of the baby unit
is too low
The camera is not turned on
Camera: the power adapter is not
plugged in
VOX mode or Standby mode are
active
The volume setting of the parent
unit is too low
Other electronic devices may be
interfering with the signal
The camera and monitor may be too
far apart
The battery power may be too low
The camera or monitor may be placed
too close to many metal objects
The AC/DC adapter is not plugged
in
A non-rechargeable battery
has been used
The camera and monitor may be
too far apart
The link between both units has
been lost momentarily
The link between both units has
been lost
Solution
Press and hold down button (III) for 2 seconds
Press and hold down the power button (5)
Plug in the power adapter
Plug in the power adapter
Move the monitor closer to the camera
Link the camera with the monitor again.
See section 5.2.7.1.3.
Change the camera number you are
watching. See section 5.2.7.1.1.
In order to view the images in colour,
increase the level of light in the room
the camera is in or check there is
nothing covering the camera´s light
sensor (II)
Set the volume to the highest level
Press and hold down button (III) for 2 seconds
Plug in the power adapter
To see the monitored area continuously,
disconnect the VOX or Standby mode on the
Monitor
Set the volumen to the highest level
Move them away from the device
Move the monitor closer to the camera
Plug in the power adapter
Move them away from the device
Plug in the adapter
Only rechargeable batteries can be used (3,7
V – 1200mAh Li-ion battery). test the battery
and, where necessary, change it for the one
supplied with the appliance
Move the monitor closer to the camera
Reset the units by disconnecting them from
the electrical power. Wait about 15 seconds
before reconnecting. Allow up to one minute
for the Baby Unit and the Parent Unit to
synchronize.
Pair the camera and monitor again. See
5.2.7.1.3.
27