Exhaust Muffler - Husqvarna TC 250 2009 Manual De Uso

MUM2-250_310_450_510_2009_GB
- Depress the pedal (2) and keep it full down.
- Loosen the bleed union letting out fluid (at first, only air will
come out), then, closing the union slightly.
- Release the pedal and wait for a few seconds before repeat-
ing the operation until only fluid come out of the tube.
52
18-11-2008 11:19 Pagina 52
- Close the bleed union to the prescribed torque and check the
fluid level (B) inside the reservoir before reassemblle the cap
(1).
If the bleeding operation has be done correctly, the pedal will
have no mushy feel. If not, repeat the operation.
NOTE
Should the motorcycle, due to a fall during a competition or
shop repairs, show some elasticity of the brake lever stroke,
with a subsequent braking efficiency decrease, you'll to repeat
the circuit bleeding as above described.
WARNING!
During the bleed operation the fluid level
inside the reservoir must never be lower
than the minimum level.
Tightening torque for bleed valve is 1,2 ÷
1,6 kgm (12 ÷ 16 Nm; 8.8 ÷ 11.8 ft-lb).
2

EXHAUST MUFFLER

The muffler reduces the noise of the exhaust gases, but it is an
integral part of the exhaust as well. As such, its conditions af-
fect the motorcycle performance.
When the noise on the exhaust is too high, it means that the
deadening material set on the holed tube inside the muffler is
deteriorated.
WARNING*: Check the deadening material
after every competition and replace it if nec-
essary.