Husqvarna TC 250 2009 Manual De Uso página 91

MUM1-250_310_450_510_2009_GB
AIR FILTER CHECK
Turn rear pin (1) counterclockwise, remove the saddle from the
front afstening screw.
Remove screw (3) and the filter (4). Separate filter (5) from
frame (6).
18-11-2008 11:10 Pagina 25
AIR FILTER AND CLEANING
Wash the filter with a specific detergent (AGIP" Filter clean
foam air detergent fluid" or similar) then dry it fully (wash fil-
ter with gasoline only in case of necessity).
Plunge the filter in special oil for filters (AGIP "Foam air filter
protection oil" or similar), then wring it to drain superfluous
oil.
CAUTION*: Do not use gasoline or a low
flash-point solvent to clean the element. A
fire or explosion could result.
CAUTION*: Clean the element in a well ven-
tilated area, and do not allow sparks or
flames anywhere near the working area.
ASSEMBLY
To ensure tight fit, slightly (C) grease filter edge on side facing
filter housing.
While re-inserting the filter into its housing, make surs that
piece A is turned upwards and edge B is on the left lower side
of the filter case. Reassemble the parts previously removed.
CAUTION*: If the element assembly is not
installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of
the piston rings and cylinder.
4
25