Problem
The microwave does not switch on. The door was not fully closed.
It takes longer than before for the
food to heat up.
A signal sounds. The two dots in
the display are flashing.
Error messages
You can take remedial action yourself for some error
messages.
Error message
Error message "Er1" or "Er4" appears
in the display.
Error message "Er11" appears in the
display. "Button jammed"
Error message "Er19" appears in the
display.
Error message "Er17", "Er18" or
"E305" appears in the text display.
Replacing the cooking compartment bulb
You can replace the cooking compartment bulb. Heat-resistant
25 watt, 240 V halogen bulbs can be obtained from the after-
sales service or from a specialist retailer.
:
Risk of electric shock!
Never replace the oven light when the appliance is switched on.
Pull out the mains plug or switch off the appliance at the circuit
breaker in the fuse box.
Note: Always remove the new halogen bulb from the packaging
using a dry cloth. This increases the service life of the bulb.
Method
Note: You must remove the whole appliance in order to replace
the cooking compartment light. Follow the installation
instructions.
Unplug the appliance from the mains or switch off the circuit
1.
breaker in the fuse box.
Open the appliance door.
2.
Undo the securing screws on the right and left-hand side of
the oven. Follow the installation instructions.
Carefully lift out the appliance.
3.
Undo the screw from the light cover on the outer left-hand
4.
side wall and remove the cover. (Fig. A) Pull out the halogen
light. (Fig. B).
Possible cause
The
button has not been pressed.
ƒ
The microwave power setting is too low.
A larger amount than usual has been
placed in the appliance.
The food was colder than usual.
The appliance is in demo mode.
Possible cause
The temperature sensor has failed.
The buttons are dirty or the mechanics have
jammed.
There is extreme overheating (possibly a fire
inside). Microwave power setting too high.
Technical malfunction.
Remedy/information
Check whether food remains or foreign material
is trapped in the door. Make sure that the seal-
ing surfaces are clean. Check whether the door
seal is twisted.
Press the
ƒ
Select a higher power setting.
Double the amount = almost double the time
Stir or turn the food during cooking
Press the
1.
Press and hold the
2.
onds.
Demo mode is deactivated.
Remedy/Note
Call the aftersales service.
Press all buttons several times and, if this
does not help, contact the after-sales ser-
vice.
Do not open the door. Disconnect from the
mains or switch off the fuse in the fuse box
and allow to cool down.
Call the aftersales service.
Insert the new halogen bulb (Fig. C)
5.
button.
°±²
button.
n
button for three sec-
39