Publicidad
Lighting
Turn on the gas supply tap .
1)
Press the knob
2)
(pos.
) to light the pilot light.
1
Keep the knob pressed for about 15 sec. to
3)
prime the thermocouple.
Turn the knob(A) anti-clockwise (pos.
4)
the burner.
Turn the knob gradually anti-clockwise to
5)
adjust the power of the fl ame down to the
minimum setting.
Turning off
Turn the knob (A) clockwise (pos. 1) to turn
1)
the burner off . The pilot light will remain on to
allow the burner to be re-lit.
Turn the knob clockwise (pos. 3) to turn off the
2)
pilot light.
Turn off the knob to ensure safety.
3)
If the appliance is to be out of use for a lengthy
period, proceed as follows.
Turn off the gas supply tap.
1)
Clean the appliance and the surrounding areas
2)
GB
thoroughly.
Spread a fi lm of edible oil over the stainless
3)
steel surfaces.
To ensure correct use of the appliance, the
following rules should be adopted.
– Use only the accessories recommended by the
manufacturer.
– SThe 7 kW burner requires pans with a diame-
ter of min 200 mm and max 420 mm; the 10
kW burner requires pans of min. 240 mm and
max 460 (500 mm only for burners working in-
dividually); the 4 kW burner requires pans with
3319960_ut_GB_rev.1
SWITCHING THE APPLIANCE ON AND OFF
and turn it anti-clockwise
(A)
LENGTHY DOWNTIMES OF APPLIANCE
INSTRUCTIONS AND WARNINGS FOR USE
) to light
2
Carry out all the servicing procedures.
4)
Cover the appliance and leave a few gaps to
5)
allow air to circulate.
a diameter of min 140 mm and max 320 mm.
– Always keep the appliance and the surroun-
ding areas clean.
– When cleaning, use only food-approved
detergents.
- 8 -
A
A
3
1
2
ENGLISH
Publicidad
