Publicidad
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screws (D) and extract the cap (E).
4)
Pull off the cone (F).
5)
Clean the cone (F) and its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times.
Pull off the cone (F) to remove the excess
8)
grease.
Replace the cone (F) and the cap (E).
9)
Replace the control panel (B) and the knobs
10)
(A) on completion of the operation.
INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
Importante
Important
Before carrying out any replacement proce-
dure, activate all the safety devices provided
and decide whether staff at work and those
in the vicinity should be informed.
In particular, turn off the gas supply tap and
prevent access to all devices which might
cause unexpected health and safety hazards
if turned on.
GB
To carry out this operation, proceed as follow.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
Replace the burner and
5)
the grid.
3319960_inst_GB_rev.1
GREASING THE GAS TAP
REPLACING PARTS
REPLACING THE TOP BURNER NOZZLE (Ø 80 - 4 KW)
A
A
B
If work parts have to be replaced, use original
spare parts only.
The manufacturer declines all responsibly for
injury or damage to components due to the use
of non original parts, or extraordinary work on
the appliance which may modify the safety re-
quirements without the manufacturer's autho-
risation.
When ordering components, follow the instruc-
tions provided in the parts catalogue.
B
- 12 -
E
C
C
D
F
8
C
ENGLISH
Publicidad
