VM Motori D703E2 Manual Instrucciones página 89

In order to guarantee the perfect con-
servation of all engine components,
an "overseas" packaging should be
used in case of maritime transport.
The packaging contains all the infor-
mation needed to carry out the load-
ing and unloading operations.
During transport, make sure the load
is properly secured to the means of
transport to avoid unexpected dis-
placements.
When transporting the uncovered en-
gine by road, use the lifting points pro-
vided to secure it steadily and prevent
components from being damaged.
UNPACKING
Follow the procedure below.
1- Remove the cover of the packag-
ing. The packaging includes a bag
with all the relevant technical docu-
mentation and standard components.
2 - While unpacking, make sure the
components are intact and their quan-
tity is correct.
3 - Place the lifting device as shown
in the figure.
4 - Loosen the screws (A) and disas-
semble the side supports (B).
5 - Move the engine to the installa-
tion area.
If necessary, keep the material in
case you need to pack the engine in
the future.
Important
In case of any damage or missing part,
contact the manufacturer's Assistance
Service to establish the procedure to be
adopted. The packaging material should
be suitably eliminated in compliance
with the applicable legislation.
English
(A)
Screw
(B)
Stay
- 27 -
Handling and installation information
D700/750 E2-E3
IDM-45300900800.tif
IDM-45300900900.tif
GB