Battery Installation; Important - Nilfisk-Advance Captor 4300B Instrucciones De Uso

A-8 / ENGLISH

BATTERY INSTALLATION

See Figure 1 & 2. The battery required for this machine is sold separately. The maximum battery weight for this machine is 1,875 lbs (850
kg); the minimum battery weight is 1,400 lbs (635kg). For proper battery installation, please consult your Nilfi sk-Advance Industrial Dealer.
DO NOT attempt to install the battery with an overhead hoist or forklift; it can only be installed with a battery cart. Connect the connector plug
(A) on the battery to the machine plug behind the steering wheel. Make sure the battery is fi rmly seated against the End Brace (B) on the
driver's side of the battery compartment. Reinstall the battery Stop Plate (C) on the left side of the compartment and snug up the Bumpers
(D) so the battery cannot slide from side-to-side. NOTE: The Battery Disconnect Tab (E) has to be assembled to the Battery Connector Plug
(A) on the battery.
WARNING!
Battery weight in excess of 1,875 lbs (850 kg) or below 1,400 lbs (635kg) may cause the premature failure of parts including
the tires, and may result in decreased stability and control, which could cause personal injury or death and/or property damage.
Use of a battery in excess of the weight limit will void the warranty.

IMPORTANT!

Follow instructions packed with the battery and charger before charging the battery. Read the instructions for Charging the
Battery in the Maintenance section of this manual.
FIGURE 1
A-8 - FORM NO. 56041577 - Captor 4300B, 4800B / CR 1100B, 1200B
™