Timed Negative Blast Chilling And Storage Cycle - eunasa 3GN 1/1 Manual De Instalación, Uso Y Mantenimiento

During chilling:
The display shows the residual chilling time remaining
- The LED is on; the Parameter r1 sets the chilling time duration
- Parameter r7 sets the operational set-point
- Press several times to:
Display the message "PoS";
Display the cabinet temperature;
Exit the procedure, or leave for 15 s.
Once the chilling period has elapsed, the device switches to storage mode and the display shows the
message "End". The buzzer sounds for the period of time set by parameter "AA". Press any key to mute the
buzzer; press once more to cancel the message "End".
During storage:
The displays shows the cabinet temperature, the LEDs
operational set-point, Press
- Display the message "PoS"
- Exit the procedure, or leave for 15 s.
To interrupt the cycle, Press

2.7 TIMED NEGATIVE BLAST CHILLING AND STORAGE CYCLE

To start the cycle:
- Ensure the device is in "stand-by" mode and no procedures are running
- Press to select "nEg" and ensure the LED
- Press within 15 s: the display will show the duration of the blast chilling step (in minutes)
- Press or
is selected, when the value assigned by parameter r2 is restored)
- Press within 15 s: the cycle will be activated.
If negative chilling and storage cycles are not enabled (parameter rb = 0), the label "nEg" will not be displayed.
During chilling:
The display shows the residual chilling time remaining
- The LED is on; the Parameter r2 sets the chilling time duration
- Parameter r8 sets the operational set-point
- Press several times to:
Display the message "nEg";
Display the cabinet temperature;
Exit the procedure, or leave for 15 s.
Once the chilling period has elapsed, the device switches to storage mode and the display shows the
message "End". The buzzer sounds for the period of time set by parameter "AA". Press any key to mute the
buzzer; press once more to cancel the message "End".
several times to:
for 2 s.
within 15 s to change the value (the setting remains active until another cycle
and are on, the parameter r9 sets the
is flashing
24