Usage Precautions; Maintenance; User Cleaning; Regular Checks - eunasa 3GN 1/1 Manual De Instalación, Uso Y Mantenimiento

To exit the procedure:
- Press and
Interrupt the device power supply after modify the parameters.
● RESETTING CONFIGURATION PARAMETER DEFAULT VALUES
- Ensure the device is in "stand-by" mode and no procedures are running.
- Press and
- Press
- Press or
- Press or leave for 15 s
- Press and
- Press
- Press or
- Press or leave for 15 s: the display will flash "dEF" for 4 s, after which the device will exit the
procedure
- Interrupt the power to the device.
Ensure that the parameter default values are appropriate.

USAGE PRECAUTIONS

2.18
• Do not hang off the doors, the machine's stability is guaranteed with the doors open.
• DO NOT USE sharp objects in the surroundings of the coolant circuit either in EVAPORATORS,
CONDENSERS, FAN PROTECTIONS, input and output lines.
• Working with wet hands or bare foot when handing the control and surroundings of electrical parts or
components is not recommended.
3

MAINTENANCE

With these guidelines, we would like to offer both you and the technical assistance service help so that the
cooler always works perfectly throughout its useful life.
We will deal with the cleaning you can carry out as well as a quick machine check before contacting the
technical support service. We hope this will be useful.

3.0 USER CLEANING

Before carrying out any cleaning operations, the appliance must be disconnected from the socket, and the
power switch turned to OFF (if your model has it).
Some models are equipped with a drainage pipe for cleaning, as well as for collecting the possible flow of
liquids from the food. It is essential to remove and clean the drainage pipe plug during the cleaning
operation, to prevent it from being blocked up with solid waste. This is so that any liquids present do not
become stagnant. It should be installed again after cleaning.
It is essential to disconnect the appliance if you are going to clean with water. Panels should not be moved
to access electrical components except by technical staff authorised to carry out maintenance and repair
operations
The inside of the cooler should be cleaned with great care.

3.1 REGULAR CHECKS

To be carried out by the User
- It is recommended that there are no heat sources near to the cooler.
- The appliance should be well levelled to prevent excessive vibrations.
- The door Joint is in good working conditions and closes hermetically with the body.
- The electricity plug is correctly connected to the socket.
for 4 s, or leave for 60 s.
for 4 s: the display will show "PA"
within 15 s to set "743"
per 4 s: the display will show "dEF"
within 15 s to set "149"
30