3. To temporarily stop heater, set thermostat at a temperature lower than air around heater. Heater will cycle
back on if air temperature around heater is lower than thermostat setting.
To ResTaRT heaTeR
CaUTIon: Do noT ResTaRT heaTeR UnTIl CoolInG CYCle Is fInIsheD.
The cooling cycle cools the combustion chamber.
1. Wait until cooling cycle is finished after stopping heater.
2. Repeat steps under TO START HEATER.
lonG-TeRM sToRaGe of heaTeR
. Remove drain bolt from rear bottom side of fuel tank by
unscrewing bolt and drain.
2. Using a small amount of kerosene, swirl and rinse the inside
of the tank. NEVER MIX WATER WITH KEROSENE, as it will
cause rust inside the tank. Pour the kerosene out, making
sure that you remove it all.
IMPoRTanT: Do not store kerosene over summer for use
during next heating season. Using old fuel may damage
heater.
3. Reinstall drain bolt as follows:
•
Insert bolt's seal head fully into drain hole so that
flange is flush to tank's bottom.
•
Insert seal cap fully into head hole so that cap flange
is flush to head flange.
IMPoRTanT: Reinstall bolt fully into hole in tank; otherwise it
will not seal completely.
•
Make sure storage place is free of dust and corrosive
fumes.
•
Store the heater in the original box with the original
packing material and keep USER'S MANUAL with
heater.
4
OPERATION
Drain Bolt
Drain Hole
Drain Bolt
Kerosene Portable Heater Manual