Run Pass/Fail Test - Promax AE-966 Manual De Instrucciones

USER'S MANUAL AE-966 / 967
Resulted line
6.2.8.2

Run Pass/Fail test

This section assumes the limit line is already defined.
Pass/Fail
condition
1. Select
1.- Press the Limit Line key.
condition
2.- Press F5 (Pass/Fail) repeatedly to
select the condition.
04/2016
Checks whether all the waveform amplitude stays
between the high limit and low limit lines.
Checks whether the peak amplitude of the waveform
stays between the high and low limit lines.
Checks whether the minimum amplitude of the
waveform stays between the high and low limit lines.
Limit Line
Pass/Fail
F 5
Page 91