Setting Up The Screen; Side View - Sim2 Multimedia Mico 50 Manual De Uso E Instalación

MiCO 50

setting up the screen

Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.
•
The projector lens should be centered in the middle of the screen. If the horizontal line passing
note
through the lens center is not perpendicular to the screen, the image will be distorted, making
viewing difficult.
•
For an optimal image, position the screen so that it is not in direct sunlight or room light. Light
falling directly on the screen washes out the colors, making viewing difficult. Close the
curtains and dim the lights when setting up the screen in a sunny or bright room.
•
A polarizing screen cannot be used with this projector.
standard setup (Front Projection)
Place the projector at the required distance from the screen according to
n
An Example of standard setup

side View

90
Top View
90
H H
•
The distance from the screen to the projector may
vary depending on the size of the screen.
•
The default setting can be used, when placing the
projector in front of the screen. If the projected image
is reversed or inverted, readjust the setting to "Floor"
for "Orientation" in the "Image" menu.
Audience
•
Place the projector so that an imaginary horizontal
line that passes through the center of the lens is
perpendicular to the screen.
2D Lens Shift Ability:
note
•
•
•
V V
13
the desired picture size. (See page 14)
Range: UP 60%, Down 25%,
Left 7.5%, Right 7.5%.
It is recommended that images be
projected onto the dashed line octagonal
area for fine image quality.
There is a tolerance of ±2.5% in the
formula above.