Appendi; Maintenance; Cleaning The Ventilation Holes - Sim2 Multimedia Mico 50 Manual De Uso E Instalación

MiCO 50
Appendix

Maintenance

Cleaning the projector
Unplug the power cord before cleaning the projector.
n
Avoid using benzene or thinner, as these can damage the finish on the cabinet
n
and operation panel.
Do not use volatile agents such as insecticides on the projector.
n
Do not leave rubber or plastic objects in contact with the projector for long periods as they may damage the finish of
n
the projector.
Wipe off dirt gently with a soft flannel cloth
n
For hard-to-remove dirt, soak a cloth in a neutral detergent diluted with
n
water, wring the cloth well and then wipe the projector.
Strong cleaning detergents may discolor, warp or damage the coating
on the projector. Make sure to test on a small, inconspicuous area on
the projector before using.
Cleaning the lens
Use a commercially available blower or lens cleaning paper (for glasses and
n
camera lenses) for cleaning the lens. Do not use any liquid cleaning agents, as
they may wear off the coating film on the surface of the lens.
The surface of the lens is easily damaged, do not to scrape or hit the lens.
n
Cleaning the exhaust and intake vents
Use a vacuum cleaner to clean dust from the exhaust vent and the
n
intake vent.

Cleaning the Ventilation holes

•
This projector is equipped with ventilation holes to ensure the optimal
operating condition of the projector.
•
Periodically clean the ventilation holes by vacuuming it off with a
vacuum cleaner.
To clean the ventilation holes:
1. Turn off the power and unplug the power cord.
2. Clean the dust off by placing the cleaner hose on the intake and
exhaust ventilation holes.
.
27
Neutral detergent
diluted with water
Cleaning
Paper
Side and Rear view
Ventilation holes