Festo HSP Serie Instrucciones De Utilizacion página 45

HSP−...
Fitting: Pneumatic components
Connecting the drive for type HSP−...−AP:
Use one−way flow control valves of type
S
GRLA−... for setting the swivel speed. The
speed will be reduced by the throttling of
the exhaust air.
Screw in both one−way flow control valves
S
on the drive.
Connect the tubing of the drive.
S
Connecting the add−on components:
Installation kit MKRP−.. (see chapter Accessories") enables the tubing and cables
to be grouped together in a flexible installation tube. The installation tube is fas
tened to the cross guide with the support, and e.g. to the sub−base or the struc
ture with the adapter bracket. The installation tube may be filled to max. 70 %.
Make sure that the moving pneumatic tubing
and electric cables are laid correctly (example
Fig. 18):
Lay the cables and tubing upwards along
S
the vertical guide rail.
Fasten the cables and tubing with cable
S
binders
on the support of the universal adapter
(A) or pass them through the two cable
channels of the universal adapter (B).
on the cable binder support (C) on the
cross guide.
Pass the cables and tubing through the
S
holes in the sub−base (E) or use protective
tubing (D).
Festo HSP−... 0308 NH English
Fig. 17
(E)
Fig. 18
(D)
(C)
(B)
(A)
45