Dual Assignment Instructions - Axxess ASWC-1 Manual Del Usuario

Dual Assignment Instructions

Nota: Seek Up and Seek Down are already set to Preset Up and
Preset Down for a long button press.
1) Turn on the ignition but do not start the vehicle.
2) Press and hold down the steering wheel button, that you want to
assign a long press function, for about 10 seconds until the LED
rapidly flashes green. At this point release the button and the LED
will go solid green.
3) Press and release the Volume Up button the number of times
corresponding to the new button number selected (refer to the chart
on p. 15). The green LED will blink rapidly when the Volume Up is
pressed and back to solid green when released. Then go to the next
step when the Volume Up button has been pressed the desired
number of times.
Caution: If more than 10 seconds elapses between a Volume Up
button press this procedure will abort, and the LED will go off.
4) To store the long press button in memory, press the button that you
assigned a long press button (the button held down in Step 1). The
LED will now go off indicating it has been stored.
Note: These steps must be repeated for each button you would like to
assign dual purpose action to.
To reset a button, back to its original use, repeat Step 1. Then press the
Volume Down button. The LED will go off and the long press mapping
for the button will be erased.
ASWC-1 Installation
14