Axxess ASWC-1 Manual Del Usuario página 20

Manual Programming Mode
4) Next, press and hold the Volume Down button until the
LED goes solid. Release the Volume Down button and the LED
will turn off; Volume Down has now been programmed.
5) At this point refer the Manual Programming Legend (p. 21) and
continue to the Seek Up/Next button.
Note: For any command that needs to be skipped, press the
Volume Up button for each one. The LED should light up each time
you press the Volume Up button.
6) After the last button on your steering wheel has been programmed,
press and hold the Volume Up button until the LED flashes slow; and
then release the Volume Up button.
Note: If at any time an error is made hold down the reset button on
the ASWC-1 for 10 or more seconds. This will restart the manual
programming. Go back to Step 4 and start again.
7) Press and hold the Volume Down button until the LED starts to
flash quickly.
8) Release the Volume Down button.
9) After approximately 4 seconds of the LED flashing quickly the LED
will go out for 2 seconds.
10) Then the LED will flash, up to 15 times, depending on what radio
is connected to the ASWC-1.
11) Make sure the number of flashes match what radio you have
installed. Refer to the Radio Legend (p.13).
Note: If the number of flashes do not match the radio you have
installed, refer to the Changing Radio Type section (p. 13).
ASWC-1 Troubleshooting
20