Axxess ASWC-1 Manual Del Usuario página 17

Note: If a pre-wired harness is being used and you have tried all the
troubleshooting steps listed above, if the ASWC-1 still does not go
to a solid LED, remove the pre-wired ASWC-1 harness and use the
harness that came with the ASWC-1.
If you have performed any of the steps above; reprogram the ASWC-1
by pressing the reset button on the ASWC-1 for 3 seconds, release, and
then follow the instructions on p. 9, starting from Step 3. If the ASWC-1
still does not go to a solid LED at the end, please refer to Manual
Programming Mode on pp. 19-21 to manually program the ASWC-1.
If the ASWC did go to a solid LED but still does not work, follow these
steps to troubleshoot the radio programming portion of the auto
programming sequence:
1) Confirm that the 3.5mm jack on ASWC-1 is connected to your
radio securely, and in the correct jack of the radio. Make sure it is
not plugged into the Bluetooth mic or AUX jack. If you are not sure
what jack to connect to the radio, please contact the radio vendor.
If the wrong jack of the radio was connected to, correct it; and then
reprogram the ASWC-1.
Note: Some radios do not use a jack for the steering wheel controls,
instead they use a wire. If so, reference Connections to be Made (p.
6), and ensure that you have the proper wire(s) connected.
2) If you are using a radio with a wire for connections instead of a jack,
make sure you have also programmed the steering wheel controls to
the radio following the instructions included with the radio. Contact
the radio vendor if you have any questions with this.
Note: This does not apply to JVC and Kenwood radios.
ASWC-1 Troubleshooting
Auto Detect Mode
17