Aswc-1 Installation; Connections To Be Made - Axxess ASWC-1 Manual Del Usuario

Connections to be made

Once you have collected or printed out the "ASWC-1 Vehicle Instructions"
for your particular vehicle, from www.axxessinterfaces.com, you're ready
to install the ASWC-1.
Note: If wiring is not available on our website for your vehicle, you will
need to obtain this yourself. Please check first with Axxess Tech Support
department at 1-800-253-TECH, as we may have this information.
Into vehicle:
1) Connect the Black wire of the ASWC-1 to the ground. You may use
the same grounding point as the aftermarket radio; but
it is highly recommended to ground the ASWC-1 to the chassis,
of the vehicle, by itself.
2) With the key in the off position, connect the Red wire of the ASWC-1
to the 12-volt accessory wire.
3) Locate the correct steering wheel control wire(s) in the vehicle's
harness, as described in the "ASWC-1 Vehicle Instructions". Connect
these wires to the ASWC-1.
Note: Metra recommends that the wires are soldered for
the best and most secure connection. Tapping style connectors
are not recommended due to a higher chance of a intermittent
connection or change in resistance values (which will cause the
ASWC-1 to fail to program).
Into radio:
1) For the radios listed below, plug the included female 3.5mm adapter
(with the Brown and Brown/White wires) into the male 3.5mm
connector of the ASWC-1 harness.
A. For Eclipse radios: Connect the Eclipse steering wheel control
wires (normally Brown and Brown/Black) to the Brown and
Brown/White wires of the ASWC-1. The Brown of the ASWC-1
goes to the Brown/Black of the Eclipse and Brown/White of the
ASWC-1 goes to the Brown of the Eclipse.

ASWC-1 Installation

6