Mast Transport Safety; Mast Assembled - Jungheinrich EKS 314 Manual De Instrucciones

2.5

Mast transport safety

IMPORTANT Use a transport retaining device (12) to prevent the driver's position carriage
(13) from sliding.
If the mast is stored on a pallet(s), fasten them securely to the mast (18).
12
17
Use the lower attachment latch (19) as the "mast bottom" strap point for securing to
the lorry/truck eyes (17).
Route the belt (16) over the lift cylinder/chains to act as the "mast top" strap point.
IMPORTANT Protect the belt placed over the lift chains with a suitable material (14).
Any supplied parts (forks (15), guide rollers etc.) can be attached to a pallet, which
can then be fastened to the mast.
2.6

Mast assembled

Safely transporting the truck with the mast assembled
NOTICE Only use belts with a rated capacity
of > 5 tons.
IMPORTANT When transporting, always relieve
the drive wheel by placing the entire
surface of a wooden beam (22)
underneath
(minimum
addition, secure the load wheels
with blocks or chocks (23).
IMPORTANT If the truck's battery is supplied in
the chassis, disconnect the battery.
At least 4 fastening/quick release belts, 2 on
the left and 2 on the right (20,21) must be at-
tached to the mast.
13
14
19 17
the counterweight
chassis width).
18
In
23
15
17
16
21
20
22
H 5