Emergency Stop Device; Driver's Cab Emergency Lowering - Jungheinrich EKS 314 Manual De Instrucciones

4.7

Emergency stop device

When the automatic emergency stop mechanism applies (e.g. if the wire guidance is
lost, electric steering fails) the truck brakes to a halt. Before starting again, the cause
of the error must be identified and corrected. Start the truck again in accordance with
manufacturer's instructions contained in these operating instructions (see "Starting
up the Truck" in Chapter E).
4.8

Driver's cab emergency lowering

Qw W
When using emergency lowering, make sure that nobody is present in the
danger zone. If a second person is used to lower the load handler via the
emergency lowering device, this person must consult with the driver. Both
people must be in a safe area to avoid danger.
The driver's cab must not be lowered when the load handler is in the rack.
The truck may only be started again once the error has been localized and
corrected.
If necessary, a second person can be deployed to lower the cabin from the ground.
– Lift up the battery panel and take the Allen key from the bracket (48) to the vent
slots (48) in the battery compartment.
– Insert the Allen key into the hole (46).
– Slowly open the drain valve (47) using the Allen key.
– The cabin will lower.
48
E 32
47
46